Needle Clamp Complete for EverSewn Sparrow X and X2

A needle clamp for the EverSewn Sparrow X and X2, supplied as a direct replacement for the worn or missing original.

This list comes from the distributor's listing for this part. If your model is not named, do not assume it fits — check the part you are removing against the specification below, or ask us with your model number before ordering.

What this part does

The needle clamp is the small block on the end of the needle bar that grips the needle shank with a screw. The thread guide eye on the clamp is often part of the same piece. Stripped threads or a lost clamp are the usual reasons to replace it.

Specifications

How to tell if this is the right one

Match by the model list. Clamps differ in bore, screw thread and whether the needle locates with a flat.

Signs you need this part

The needle works loose while sewing, the screw will not tighten, or the thread guide eye is broken off.

Fitting it

Loosen the screw, slide the old clamp off the needle bar, slide the new one on and tighten with the needle fitted.

Questions about this part

Does this needle clamp fit the EverSewn Sparrow X?

Yes. The EverSewn Sparrow X is on the distributor's fitment list for this part, along with X2. If your model is not listed on this page, send us the model number and we will check before you order.

Is this the original EverSewn part?

It is listed by our distributor under the Eversewn brand name. We describe every part exactly as the distributor lists it and make no claim beyond that.

How long does delivery take?

Orders are dispatched from our distributor's US warehouse. We do not hold stock ourselves and cannot promise same-day dispatch; current delivery estimates are shown at checkout, and we will email you if an item is back-ordered.