Needle Bar Supporter Cpl for EverSewn Sparrow X and X2

Replacement needle bar for EverSewn Sparrow X and X2. The fitment below is taken from the distributor's own listing for this part.

This list comes from the distributor's listing for this part. If your model is not named, do not assume it fits — check the part you are removing against the specification below, or ask us with your model number before ordering.

What this part does

The needle bar is the vertical shaft that carries the needle clamp and moves the needle up and down. It is replaced after a bent bar from a jam, or when the clamp mount is damaged.

Specifications

How to tell if this is the right one

Match by the model list exactly. Needle bars differ in length, diameter and the position of the clamp mount, and the height is set during installation.

Signs you need this part

The needle hits the plate or hook at one side, the bar is visibly bent, or the needle clamp will not tighten.

Fitting it

Replacing a needle bar requires re-setting the needle bar height and hook timing. Unless you are comfortable with this, have it fitted by a technician.

Questions about this part

Does this needle bar fit the EverSewn Sparrow X?

Yes. The EverSewn Sparrow X is on the distributor's fitment list for this part, along with X2. If your model is not listed on this page, send us the model number and we will check before you order.

Is this the original EverSewn part?

It is listed by our distributor under the Eversewn brand name. We describe every part exactly as the distributor lists it and make no claim beyond that.

How long does delivery take?

Orders are dispatched from our distributor's US warehouse. We do not hold stock ourselves and cannot promise same-day dispatch; current delivery estimates are shown at checkout, and we will email you if an item is back-ordered.