Feed Dog for Bernina 700, 830 and 900 (Compatible)

A feed dog for the Bernina 700, 830 and 900, supplied as a direct replacement for the worn or missing original. This is a compatible replacement part rather than a manufacturer-original part.

This list comes from the distributor's listing for this part. If your model is not named, do not assume it fits — check the part you are removing against the specification below, or ask us with your model number before ordering.

What this part does

The feed dogs are the toothed bars under the needle plate that move the fabric forward one stitch length at a time. Teeth wear flat with use and the fabric stops feeding evenly, particularly on fine or slippery cloth.

Specifications

How to tell if this is the right one

Match by the model list. Feed dogs are specific to the needle plate slot layout, tooth count and the mounting on the feed bar.

Signs you need this part

Fabric does not feed, feeds unevenly, drifts to one side, or the stitch length is shorter than set. Teeth visibly rounded or chipped.

Fitting it

Remove the needle plate, release the feed dog screws from above, swap and refit. Check the feed dog height against the manual before sewing.

Questions about this part

Does this feed dog fit the Bernina 700?

Yes. The Bernina 700 is on the distributor's fitment list for this part, along with 830 and 900. If your model is not listed on this page, send us the model number and we will check before you order.

Is this the original Bernina part?

No — it is a compatible aftermarket part made to fit the models listed. It is not a manufacturer-original part.

How long does delivery take?

Orders are dispatched from our distributor's US warehouse. We do not hold stock ourselves and cannot promise same-day dispatch; current delivery estimates are shown at checkout, and we will email you if an item is back-ordered.